How to Replace Yamaha FJR1300 Starter Motor

Firstly, you need to source a replacement starter motor which can be found by Clicking Here  

Replacing the starter motor on your Yamaha FJR1300 is a relatively straightforward process, but it requires attention to detail and the right tools. Here’s a step-by-step guide to help you through the process:

Tools and Materials Needed:

1. New starter motor compatible with your Yamaha FJR1300 model
2. Socket wrench set
3. Allen wrench set
4. Screwdrivers (both Phillips and flathead)
5. Torque wrench
6. Clean rags
7. Service manual (optional but highly recommended)

Step 1: Preparation

1. Ensure your motorcycle is turned off and parked on a flat, stable surface.
2. Allow the engine to cool down if it has been recently running.
3. Disconnect the battery to prevent any electrical mishaps during the replacement process.
4. Familiarize yourself with the location of the starter motor on your Yamaha FJR1300. It’s typically located near the engine, often on the lower part of the engine casing.

Step 2: Locate and Access the Starter Motor

1. Depending on your motorcycle’s design, you may need to remove some fairings or covers to access the starter motor.
2. Consult your service manual for specific instructions on accessing the starter motor.

Step 3: Remove Mounting Bolts

1. Once you have access to the starter motor, locate the mounting bolts securing it in place.
2. Use the appropriate tools to loosen and remove these mounting bolts, ensuring you keep track of them for reassembly.

Step 4: Disconnect Electrical Connections

1. Identify the electrical connections attached to the starter motor, including any wires or cables.
2. Carefully disconnect these electrical connections, ensuring you note their positions or take a photo for reference during reassembly.

Step 5: Remove Old Starter Motor

1. With the mounting bolts and electrical connections removed, carefully pull the old starter motor away from the engine casing.
2. Take care not to damage any surrounding components as you remove the starter motor.

Step 6: Install New Starter Motor

1. Position the new starter motor in place on the engine casing, aligning it properly with the mounting holes.
2. Secure the new starter motor in place using the mounting bolts removed earlier. Tighten the bolts to the manufacturer’s specifications using a torque wrench.
3. Reconnect the electrical connections to the new starter motor, ensuring all connections are secure and properly seated.

Step 7: Reassemble Fairings or Covers

1. If you removed any fairings or covers to access the starter motor, carefully reassemble them onto the motorcycle using the appropriate bolts or fasteners.

Step 8: Reconnect Battery and Test

1. Reconnect the battery to the motorcycle.
2. Turn on your motorcycle and verify that the new starter motor is functioning properly.
3. Check for any unusual noises or abnormalities before attempting to start the engine.

Additional Tips:

• Refer to your motorcycle’s service manual for specific instructions and torque values.
• Take your time and work carefully to avoid damaging any components.
• If you’re unsure about any step, don’t hesitate to consult with a professional mechanic or refer to online tutorials/resources.

By following these steps carefully, you should be able to successfully replace the starter motor on your Yamaha FJR1300 and ensure your motorcycle starts reliably.

How to Replace Yamaha FJR1300 Starter Motor ~ Sorted !